S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

Features of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

• Torque 32NM
• 0(4)…20mA   0(2)…10V
• Maximum round shaft φ20 and square shaft 16*16mm.
• Direction of rotation can be set.
• Manual Override
• With 2 auxiliary switches are optional
• Power supply AC/DC 24V or AC 230V
• Modulating

Outline and Dimension of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

Technical Datasheet of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

Remark: After lead to the actuator wire through PG joint, the protection level can reach IP54.

Angle of Rotation Limiting of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

The rotation angle or working range of the actuator can be adjusted 5°by adapter so that can limit mechanically. You just press the locking clip to lose the adapter.

Wiring Diagram of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

0(4)…20mA and 0(2)…10V

The actuator’s main/subsidiary control:

Signal Control and Changing Direction of Rotation of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

The electronic controller of VR1 and VR2 can set the scope of control signals discretionally. VR1 is used for setting high-grade signals. And VR2 is used for setting low-grade signals. The leaving factory setting positions are matched with the control signal of 0…20mA, 0…10V.

Setting the Angle of Direction of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

Must make the contact pin(C) is as Same direction as motor plug.

Factory setting:

Switch a at 10° Switch b at 80° The switching position can be manually changed to any required position by turning the ratchet.

Auxiliary Switch of S6061-32A Damper Actuator Standard Damper Actuator (Non Fail-Safe Damper Actuators)

There are two auxiliary switches of S6061-32AF damper actuator, can set the angle 0-90° (factory sets 10° and 80°), it will show a signal when the actuator turns to the setting angle.