+86-10-67886688
SEARCH
+86-10-67886688
SEARCH
+86-10-67886688
SEARCH
S6061-08/16Nm Modulating Type Rapid Running Damper Actuator is specially designed for small air damper and terminal control unit of air volume air system. Due to the small size and control flexibly, also usually used in space where is limited.
| Item | Unit | S6061-08
AFK |
S6061-16
AFK |
S6061-08ANK | S6061-16ANK | |
| Torque | Nm | 8 | 16 | 8 | 16 | |
| Damper area | m2 | 2 | 4 | 2 | 4 | |
| Running time | sec | 8 | 16 | 8 | 16 | |
| Power supply | V | 24VAC/DV | ||||
| Frequency | Hz | 50/60
7.5W 50/60Hz |
||||
| Running consumption | W | 8.5W | ||||
| Maintaining consumption | W | 0.7W | ||||
| Weight | Kg | 1.Kg | ||||
| Control signal | 0(4)…20mA 0(2)…10V | |||||
| Rotation angle | 0~90º（Max 93°） | |||||
| Limited angle | 5~85º（Per step 5º） | |||||
| Auxiliary switch rating | 3（1.5）Amp 250V | |||||
| Life cycle | >70000 cycles | |||||
| Noise level | 45dB(A) | |||||
| Electrical level | Ⅱ | |||||
| Protection level | IP44 or IP54 | |||||
| Ambient Temperature | -20~+50℃ | |||||
| Ambient Humidity | 5~95%RH | |||||
| Storage temperature | -40~+70℃ | |||||
| Certificate | CE UL（Except 230V） | |||||
Remark: After lead out the Actuator wire by PG joint, the IP Protection can reach IP54.
The rotation angle or working range of the actuator can be adjusted 5°by adapter so that can limit mechanically. You just press the locking clip to lose the adapter.
S6061-08/16AK Damper Actuator can operate by 0(4)…20mA and 0(2)…10V
The electronic controller of VR1 and VR2 can set the scope of control signals discretionally. VR1 is used for setting high-grade signals. And VR2 is used for setting low-grade signals. The leaving factory setting positions are matched with the control signal of 0…20mA, 0…10V.
Must make the contact pin(C) is as Same direction as motor plug.
Switch at 10° – Switch b at 80°
The switching position can be manually changed to any required position by turning the ratchet.
There are two auxiliary switches of S6061-08/16AFK damper actuator, can set the angle 0-90° (factory sets 10° and 80°), it will show a signal when the actuator turns to the setting angle.
Product Inquiry
