Soloon Controls (Beijing) Co., Ltd. +86 10 67863711
soloon-logo
soloon-logo
Contact Us
S6025 Fluid Level Switch

OEM Manufacturer Air Pressure Sensor Hvac - S6022 Flow Switch – Soloon

OEM Manufacturer Air Pressure Sensor Hvac -
 S6022 Flow Switch  – Soloon
Adhering for the theory of quality, services, performance and growth, we have received trusts and praises from domestic and worldwide shopper for Hvac Heat Sensor , 2 Way Electric Ball Valve , Electric Control Ball Valve , As an expert specialized in this field, we are committed to solving any problem of high temperature protection for users.
OEM Manufacturer Air Pressure Sensor Hvac - S6022 Flow Switch – Soloon Detail:

Feature of S6025 Fluid Level Switch

Rated voltage VRated Current A Power COS ø 125VAC 250V AC
No induced load current 1 15 15
Induced load Full load current 0.75 3.5 2.5
Current Instantaneous current 0.45 21 15

Figure1: Technological Parameter 1

Valve Size Connector MaxPressure

(Mpa)

Protection AllowableMedium Temp. Wet.(Kg) Modulating Range of Flow
Pipe Size Min. Max.
Flow decrease Flow increase Flow decrease Flow increase
3″ 1″-11½ (NPT) 1.60 IP65 -30~120 0.6 1″ 2.5 4.2 8.5 8.8
2″ 9.5 13.7 27 29
3″ 19 27.5 50 53

Figure 2: Technological Parameter 2

When there is sufficient fluid through the pipe, the loop closes up between red and blue contacts.

s6022-flow-switch-2

Mounting of S6022 Flow Switch

  • Mount the switch in a section of pipe where there is a straight run of at least five pipe diameters on each side of the flow switch.
  • The switch should be mounted so that the terminals or wire leads are easily accessible for wiring.
  • Screw the flow switch into position so that the flat of the paddle is at a right angle to the flow. The arrow on the side of the case must point in the direction of the flow.
  • The switch must be mounted in a horizontal pipeline or a vertical pipeline with upward liquid flow. It is not recommended for installation where liquid flow is downwards. When mounted in a vertical pipe with the upward flow the switch trips will operate at a slightly higher flow than shown in Figure 4: “Typical Flow Rates”, due to the effect of gravity on the switch mechanism.
  • All wiring connections must be made using copper conductors only.
  • All wiring must be installed in accordance with the National Electric Code and local regulations

Flow Rate of S6022 Flow Switch

 

* + GPM figures are for a switch with a 6” paddle.

* For 4” and 5” line pipes, the 6” paddle is trimmed to a 4” and 5” length, respectively.

* For switching action, refer to figure 3.

GPM (m3/hr) Required to Actuate Switch
Pipe Size (in.) 1 1-1/4 1-1/2 2 2-1/2 3 4* 5* 6* 8*
Minimum Adjustment Flow increasingred→yellow

closed**

4.2(1.0) 5.8(1.3) 7.5(1.7) 13.7(3.1) 18.0(4.1) 27.5(6.2) 65.0(14.8)

37.0+

(8.4)

125.0(28.4)

57.0+

(12.9)

190.0(43.1)

74.0+

(16.8)

375.0(85.2)

205.0+

(46.6)

Flow decreasingred→blue

closed**

2.5(0.6) 3.7(0.8) 5.0(1.1) 9.5(2.2) 12.5(2.8) 19.0(4.3) 50.0(11.4)

27.0+

(6.1)

101.0(22.9)

41.0+

(9.3)

158.0(35.9)

54.0+

(12.3)

320.0(72.7)

170.0+

(38.6)

Maximum Adjustment Flow increasingred→yellow

closed**

8.8(2.0) 13.3(3.0) 19.2(4.4) 29.0(6.6) 34.5(7.8) 53.0(12.0) 128.0(29.1)

81.0+

(18.4)

245.0(55.6)

118.0+

(26.8)

375.0(85.2)

144.0

(32.7)

760.0(172.6)

415.0+

(94.2)

Flow decreasingred→blue

closed**

8.5(1.9) 12.5(2.8) 18.0(4.1) 27.0(6.1) 32.0(7.3) 50.0(11.4) 122.0(27.7)

76.0+

(17.3)

235(53.4)

111.0+

(25.2)

360.0(81.8)

135.0+

(30.7)

730.0(165.8)

400.0+

(90.8)


Product detail pictures:

OEM Manufacturer Air Pressure Sensor Hvac -
 S6022 Flow Switch  – Soloon detail pictures


Related Product Guide:

It really is our obligation to satisfy your requirements and efficiently serve you. Your fulfillment is our greatest reward. We're hunting forward to your check out for joint development for OEM Manufacturer Air Pressure Sensor Hvac - S6022 Flow Switch – Soloon , The product will supply to all over the world, such as: Netherlands , Egypt , Seattle , With strong technical strength and advanced production equipment, and SMS people purposefully , qualified, dedicated spirit of enterprise. Enterprises took the lead through the ISO 9001:2008 international quality management system certification, CE certification EU ; CCC.SGS.CQC other related product certification. We look forward to reactivating our company connection.
Contact Us Product Inquiry
Contact Us
If you are interested in our products.
Please fill in the form & Contact Us.
+86 10 67863711