China Low MOQ for Motorized Knife Gate Valve - S6062A Control Valve Actuator – Soloon Manufacturer and Supplier

To continuously increase the administration process by virtue of the rule of sincerely, good religion and excellent are the base of company development, we commonly absorb the essence of linked goods internationally, and continually build new solutions to fulfill the requires of shoppers for 12v Ball Valve Actuator , Air Conditioner Thermostat Replacement , Remote Control Valve Actuators , our merchandise have superior popularity from the whole world as its most competive cost and our most advantage of after-sale assistance for the clients。

Low MOQ for Motorized Knife Gate Valve - S6062A Control Valve Actuator – Soloon Detail:

Features of S6062A Control Valve Actuator

Die-casting aluminum bracket and ABS cover
Actuator can meet different pressure demand
Synchronous motor, equip with shut power function, it can open at any position due to supply stable torque
forward and reversal control setting meet different valve body

Installation and Cautions of S6062A Control Valve Actuator

1. Reserve enough space for maintenance during installation.

2. The wiring shall comply with the national electrical construction specification, and conducted in the case of power off.

3. The actuator should not be covered by thermal insulation material to prevent it from heat dissipation.

4. Vertical installation should be given priority, and inclined or horizontal installation can be adopted in special occasions, but support and fixation should be added when the volume, weight and vibration are too large.

5. Manual valves are recommended to be installed at both ends of the control valve to facilitate maintenance. During use, grease should be added regularly for three or four months.

6. When the installation position of the control valve is not indicated on the design drawing, the control valve is generally installed on the return water pipe.

Installation Diagram of S6062A Control Valve Actuator

Installation_Diagram1

1. Insert the actuator into valve stem

Installation_Diagram2

2. Tight two screws use hex key

Installation_Diagram3

3. Use manual lever to adjust the stroke, then put gasket into slot, last tight the nut

Attention: the assemble must vertical between actuator and valve body

Dimension of S6062A Control Valve Actuator

Dimension-of-S6062A-Control-Valve-Actuator

Manual Operation:

1. Insert handle

2. Rotate “UP” and “DOWN”.

Technical Parameter of S6062A Control Valve Actuator

Item No.	S6062A-DV	S6062A-FV	S6062A-MV
Voltage	AC220±15%	AC24V±15%	AC24V±15%
Power	16VA
Input Signal	on off	Floating	0-10VDC/4-20mA
Feedback Signal	——-	——	0-10VDC/4-20mA
Act Speed(mm/s)	0.20(50Hz)
Max. Stroke(mm)	44mm
Output Force(N)	2500/4000/5000
End Connection	Buckle
Height(mm)	379
Weight(kgs)	4.7

Environment Temperature: -5℃~55℃ 2.Storage Temperature：-2℃~85℃ 3. Protect Class: IP 44

Low MOQ for Motorized Knife Gate Valve - S6062A Control Valve Actuator – Soloon

Features of S6062A Control Valve Actuator

Installation and Cautions of S6062A Control Valve Actuator

Installation Diagram of S6062A Control Valve Actuator

Dimension of S6062A Control Valve Actuator

Technical Parameter of S6062A Control Valve Actuator

Modulating Wiring of S6062A Control Valve Actuator

The Manufacturer of HVAC Control Valves and Valve Actuators

The HVAC Actuator Valve Working Principle

HVAC Control Valves and Actuators