Maximum round shaft φ20 and square shaft 16*16mm.
Direction of rotation can be set.
With 2 auxiliary switches are optional
Power supply AC/DC 24V or AC 230V
5~85º（Per step 5º）
Auxiliary switch rating
IP44 or IP54
Remark: After lead to the actuator wire through PG joint, the protection level can reach IP54.
The rotation angle or working range of the actuator can be adjusted 5°by adapter so that can limit mechanically. You just press the locking clip to lose the adapter.
0(4)…20mA and 0(2)…10V
The actuator’s main/subsidiary control:
The electronic controller of VR1 and VR2 can set the scope of control signals discretionally. VR1 is used for setting high-grade signals. And VR2 is used for setting low-grade signals. The leaving factory setting positions are matched with the control signal of 0…20mA, 0…10V.
Must make the contact pin(C) is as Same direction as motor plug.
Switch a at 10° Switch b at 80° The switching position can be manually changed to any required position by turning the ratchet.
There are two auxiliary switches of S6061-32AF damper actuator, can set the angle 0-90° (factory sets 10° and 80°), it will show a signal when the actuator turns to the setting angle.